CYBEX Plate Loaded 16120 Smith Press - Cable Installation; Securely Anchor Machine to Floor

Cybex Plate Loaded 16120 Smith Press Owner’s Manual
14
6. Cable Installation.
• Locate two Hex Head Cap Screw HHCS from shipping package.
• Place a small drop of loctite on HHCS and in threaded hole.
• Using a 7/16” wrench, attach cable end to weight bar bracket with HHCS. Cable end must
be attached straight to avoid a kink in cable.
• Repeat step 6 for opposite cable end.
HHCS
Cable
End
Cable
Weight Bar Bracket
Cable end must be attached
straight to avoid kink in cable.
7. Securelyanchormachinetotheoorusingtheanchorholesprovidedineachmachine.
CAUTION: Cybex is not responsible for the actual anchoring of equipment. Consult with
a professional contractor.
WARNING: Use fasteners having a minimum of 500 lbs. tensile capacity (3/8’’ grade 2
bolts or better).
WARNING: If legs/frame does not contact surface, DO NOT pull down with anchors. Shim
any leg or frame not in contact with surface using at washers.
8. Verify proper operation.