5
Thank you for deciding on the Solution B2-Fix + when choosing your
child seat.
Carefully read the instructions before installing the seat in your car and
always keep these instructions to hand in the designated compartment.
IMPORTANT INFORMATION
!
Without the approval of the Type Approval Authority, the child seat may not
!
In order to keep your child properly protected, it is absolutely essential that
you use the child seat as described in this manual.
!
This child seat may only be installed on vehicle seats which are approved
for the use of child restraint systems according to the vehicle manual.
!
Only suitable for vehicle seats with automatic three-point belts approved in
accordance with UN regulation 16 or a comparable standard.
!
Do not use any load bearing contact points other than those described in
the instructions and marked on the child restraint.
!
The full surface of the backrest of the child seat must make contact with
the backrest of the vehicle.
!
The shoulder belt must run upwards and back at a recline. It must never
run forward to the upper belt point in your vehicle.
!
The vehicle belt buckle must never cross the belt guide of the seat. If
the belt whip is too long, the child seat is not suitable for use in this
position in the vehicle. In case of doubt please contact the child restraint
manufacturer.
!
The three-point vehicle belt must only be passed through the designated
routings. The belt routings are described in detail in this manual and are
marked in red on the child seat.
!
The lap belt must run as low as possible across your child’s groin to have
!
Before each use make sure that the automatic three-point vehicle belt is
!
smoothly.
!
The child seat must always be secured correctly with the vehicle belt in the
vehicle even when not in use.
!
Always ensure that the child seat is never jammed when closing the car
door or adjusting the back seat.
!
The child seat is also tested and homologated without the Linear Side
impact Protectors.
!
secured. Otherwise, they may be thrown within the car, which could cause
fatal injuries.
!
The child seat must never be used without the seat cover. Ensure that only
an original CYBEX seat cover is used, as the cover is a key element of the
seat’s function.
!
Never leave your child unattended in the car.
!
The parts in the child restraint system heat up in the sun and could
direct sun exposure.
!
with the naked eye. Please replace the seat after an accident. In case of
doubt, please consult your dealer or the manufacturer.
!
Do not use this child seat for more than 9 years. The child seat is exposed
to high stress during its product life span, which leads to changes in the
quality of the material with increasing age.
!
The plastic parts can be cleaned with a mild cleaning agent and warm
water. Never use harsh cleaning agents or bleaches!
!
On some vehicle seats made of sensitive materials, the use of child seats
may leave marks and/or cause discolouration. To prevent this, you can
place a blanket or towel or similar underneath the child seat to protect the
vehicle seat.
SOLUTION B2-FIX +
UN-R44-04
UNIVERSAL
SEMI-UNIVERSAL
15 – 36 kg
CYBEX GmbH
Riedingerstr. 18, 95448 Bayreuth
Germany
04301395
CERTIFICATION
UN R-44/04
CYBEX Solution B2-Fix + - group 2/3, 15 to 36 kg
Recommended from approx. 3 years to 12 years
EN
To Next Page
Loading...
Need help?
General
