CYCLOPS 661-3 - Page 2

-2-
OPTION SETTINgS
Passive Arm / Transmitter Code-Learning / Passive Lock / Ignition
Lock &Unlock / Set Override PIN.
. Disarm the alarm by pressing the UNLOCK/DISARM button.
2. Open the driver’s door and leave door open.
3. Turn ignition switch On the number of times corresponding to
the feature you wish to alter. Refer to the Option Table for option
selection number.
4. When the correct count is reached, leave ignition switch ON.
5. Vehicle indicators will ash when alarm is ready to change option.
6. Press the LOCK/ARM button on a valid remote control.
7. Alarm will ash vehicle indicators to conrm change, see option
table for one/three ash meaning.
OPTION SETTINgS
Passive Arm / Transmitter Code-Learning / Passive Lock / Ignition
Lock &Unlock / Set Override PIN.
. Disarm the alarm by pressing the UNLOCK/DISARM button.
2. Open the driver’s door and leave door open.
3. Turn ignition switch On the number of times corresponding to
the feature you wish to alter. Refer to the Option Table for option
selection number.
4. When the correct count is reached, leave ignition switch ON.
5. Vehicle indicators will ash when alarm is ready to change option.
6. Press the LOCK/ARM button on a valid remote control.
7. Alarm will ash vehicle indicators to conrm change, see option
table for one/three ash meaning.
*** Warning this function can result in keys being locked in
vehicle!!
Ignition
Switches
Feature One Flash Three
Flashes
3 Anti-Hijack Disabled Enabled
5 Passive arming Disabled Enabled
7 Program new remote Press new remote control
13
Chirps for ARM /
DISARM
Disable Enable
15
Passive Locking Disabled Enabled
19
Set new PIN Begin changing PIN
EMERgENCY PIN OVERRIDE
In the event a remote is lost, stolen or broken, the 661-3 alarm
system may be overridden by using the programmed two digit
Personal Identication Number (PIN).
1. Insert ignition key into vehicle ignition switch.
2. Turn key to the ON position (the position just before engine
crank). The red status LED will glow constantly.
3. Return the key to the ACC position (the rst position that powers
your radio).
4. The status LED will begin ashing slowly. Count the ashes.
5. When the ashes match the rst number in your PIN, turn the
ignition switch to the ON position again.
6. Repeat step #5 for the second digit of the PIN.
7. The status LED will extinguish and the 66-3 will now be
disarmed and engine will start.
PROgRAMMINg NEW PIN
. Disarm the alarm by pressing the UNLOCK/DISARM button.
2. Open the driver’s door and leave door open.
3. Switch ignition switch Off and On 19 times.
4. When the 19th count is reached, leave ignition switch ON.
5. Vehicle indicators will ash when alarm is ready accept new
remote PIN.
6. Press the LOCK/ARM button the number of times corresponding
to the rst digit of the new PIN. Press UNLOCK/DISARM the
number of times corresponding to the second digit of the new PIN.
This step is critical, the timing between pressing the LOCK/ARM
button and pressing UNLOCK/DISARM must be as short as
possible. Any unprovoked indicator ash before the UNLOCK/
DISARM button is pressed means the PIN programming procedure
has dropped out - start again!!!
7. Alarm will ash vehicle indicators three times to conrm
successful programming.
*** All central locking and boot release features require additional
hardware, which is not supplied with the 661-3 alarm system.
Vehicles with central locking and/or electronic boot release will still
require connections to the 661-3 which are not a part of a standard
installation.
Control Module Siren and Remotes
CYCL PS
VEHICLE SOLUTIONS