25
• Bezel and Gap Compensation
This section of the Video Wall tab is used to dene the physical
dimensions of each display being used in the video wall. Accurate
measurements are needed of the monitor’s outer frame (OW, OH)
and the video screen (VW, VH). The measurements may be made
using any unit of measurement (inches, mm, cm, etc.) as long as ALL
measurements in the same wall are made using the exact same units
and the numbers are integers.
- OW (Outer Width): This is the horizontal measurement of the
display’s outer case.
- OH (Outer Height): This is the vertical measurement of the display’s
outer case.
To Next Page
Loading...
