33
• Serial over IP
This section provides controls for the Serial over IP extension
functionality, including enabling/disabling Serial support and setting
the RS-232 data conguration.
- Enable Serial over IP: Unchecking this checkbox will completely
disable support for sending RS-232 commands over this stream.
This option should generally remain checked, but, if serial support
is not required, disabling this feature can save a very small amount
of bandwidth.
- Serial Settings: Set the desired baud rate, data bits, parity, and
stop bit for the RS-232 signal to extend.
Note: The Transmitter and Receiver must have the same serial
settings.
To Next Page
Loading...
