Cyrus DAC X+ - User Manual

Questions and Answers

J
jacquelinefrenchAug 11, 2025
How to fix a Cyrus Media Converter remote control that is not operating?
- S
  Steven PhillipsAug 11, 2025
  If the remote control for your Cyrus Media Converter isn't working, here's what you can do: * If the lights on the remote are weak or not flashing when commands are sent, check the batteries and replace them if needed. * If the lights are flashing correctly, ensure that the correct system has been selected on the remote for the components you are operating.
J
jgibsonAug 17, 2025
How to troubleshoot no sound from all speakers on my Cyrus Media Converter?
- J
  Jacqueline SantosAug 17, 2025
  If you're not getting any sound from any speaker, regardless of the source, here's what to check: 1. Make sure all of your system amplifiers are switched on. 2. Power off your audio system and then carefully check that all connections from the DAC to the system amplifiers and speakers are correctly and securely connected.
F
frenchmaryAug 23, 2025
What to do if there is no sound from one source on my Cyrus DAC X+ Media Converter?
- B
  Betty GriffithAug 23, 2025
  If you're experiencing a lack of sound from a specific source on your Cyrus Media Converter, consider the following: * Verify that you've selected the correct source. * Ensure the input is correctly named. * Check if the source is paused. * Confirm that the audio format of the disc or tape is compatible with your DAC. * Power down the audio system and double-check that the connections from the source to the DAC are properly established.
M
melinda88Aug 29, 2025
Why is there no sound from one loudspeaker connected to my Cyrus Media Converter?
- J
  Jessica BlairAug 29, 2025
  If you're not getting sound from one loudspeaker connected to your Cyrus Media Converter, try these steps: 1. Ensure the balance control isn't set to an extreme limit; centralize it. 2. Check the speaker's fuses and replace them if necessary. 3. If you're using a DAC XP+, the power amplifier might be faulty. To test this, switch off the power to the audio system before exchanging the left and right output channels from the DAC XP+.
S
Samantha AlvarezSep 4, 2025
What to do if Cyrus DAC X+ Media Converter speakers make loud noises with certain sources?
- D
  Donald ParkerSep 5, 2025
  If you're hearing loud noises from the speakers when using specific sources or discs with your Cyrus Media Converter, check the audio format of the disc or tape to ensure it is compatible with the DAC.