Remote Transmitters Programming
•Press the “S” Button for ±2 seconds until the “S” LED glows.
•Release the “S” Button.
•Press and the required button on the Remote Transmitter to be programmed.
• “S” LED flashes briefly.
• Press the same Remote Transmitter button again.
• “S” LED flashes ±3 times.
• Press the same Remote Transmitter button for the third time.
•The opener/door will start operating.
•The selected button on the Remote Transmitter is now coded.
IMPORTANT
Up to 6 codes can be programmed by the opener.
Decoding a Remote Transmitter will cause all coded remotes to be decoded.
Coding a Remote Transmitter
•Press and hold the “S” Button for ±6 seconds.
•The “S” LED glows briefly.
•Release the “S” Button.
•All stored codes are now erased/All Remote Transmitters are now de-coded.
De-Coding a Remote Transmitter - erase code
To Next Page
Loading...