34
Using the Configuration Menu
Advanced > Performance
Beacon Interval
Beacons are packets sent by an Access Point to synchronize a
wireless network. Specify a value. 100 is the default setting and is
recommended.
TX Rates
Select the data rate. Default is 1-2-5.5-11-22Mbps.
DTIM interval
(Delivery Traffic Indication Message) 3 is the default setting. A DTIM
is a countdown informing clients of the next window for listening to
broadcast and multicast messages.
Basic Rates
Preamble Type
Select the data rate. Default is 1-2-5.5-11-22Mbps.
Long preamble is the default setting. (High traffic networks should
use the shorter preamble type.) The preamble defines the length of
the CRC block used in communication between the Access Point
and the roaming wireless Network adapters.(Cyclic Redundancy
Check is a common technique for detecting data transmission errors)
To Next Page
Loading...
