36
Using the Configuration Menu
Tools> Admin
Password
Remote
Management
To change the admin and user passwords, enter in the old pass-
word, and enter the new password twice to confirm.
There are two accounts that can access the Broadband Router’s Web-Management
interface. They are admin and user. Admin has read/write access while user has read-
only access. User can only view the settings but cannot make any changes. It is recom-
mended that you change the admin password from the default setting. The default pass-
word is blank (no password).
Remote Management allows the device to be configured through
the WAN (Wide Area Network) port from the Internet using a
web browser. A username and password is still required to
access the browser-based management interface.
IP Address Internet IP Address of the computer that has access to the
DI-614+. If the IP Address is set to 0.0.0.0, this allows all Internet
IP addresses to access the DI-614+.
Port
The port number used to access the DI-614+.
E.g., http://x.x.x.x:80, where x.x.x.x. is the WAN IP address of
the DI-614+ and 80 is the port used for the Web Management
interface.
To Next Page
Loading...
