D-Link DAP-1360U

DAP-1360U Quick Installation Guide
Conguring Wireless Network
This configuration step is available for the Router, Access point, WISP
Repeater, Repeater, and WDS modes.
1. On the Wireless Network 2.4 GHz page, in the Network name field,
specify your own name for the wireless network or leave the value
suggested by the access point.
2. In the Password field, specify your own password for access to the
wireless network or leave the value suggested by the access point (WPS
PIN of the device, see the barcode label).
3. If the access point is used as a Wi-Fi client, you can specify the same
parameters of the wireless network as specified for the network to which
you are connecting. To do this, click the USE button (available for the
Repeater mode only).
4. You can restore the parameters of the wireless network specified before
resetting to factory defaults. To do this, click the RESTORE button.
26