D-Link DAP-1360U

DAP-1360U Quick Installation Guide
Changing LAN IPv4 Address
This configuration step is available for the Access point, WDS, Repeater,
and Client modes.
1. Select the Automatic obtainment of IPv4 address to let DAP-
1360U automatically obtain the LAN IPv4 address.
2. In the Hostname field, you should specify a domain name of the access
point using which you can access the web-based interface after finishing
the Wizard. Enter a new domain name of the access point ending with
.local or leave the value suggested by the access point.
!
In order to access the web-based interface using the domain name, i n the
address bar of the web browser, enter the name of the access point with a
dot at the end.
If you want to manually assign the LAN IPv4 address for DAP-1360U, do not
select the Automatic obtainment of IPv4 address checkbox and fill in
the IP address, Netmask, Hostname fields and, if needed, the Gateway
IP address field. Make sure that the assigned address does not coincide with
the LAN IPv4 address of the router to which your device connects.
3. After changing the LAN IPv4 address of the device, make sure that the
network adapter settings correspond to the new parameters.
4. Click the NEXT button.
20