DAP-1360U Quick Installation Guide
Configuring Local Area Network
1. Go to the Connections Setup / LAN page.
2. If needed, change the IPv4 address of the access point's LAN interface
and the mask of the local subnet. To do this, specify needed values in the
IP address and Mask fields in the Local IP Address section.
3. IPv4 address assignment. By default, the DHCP server of the device
in the access point mode is disabled (the Disable value is selected from
the Mode of dynamic address assignment drop-down list). As a
rule, the DHCP server should be disabled when the device is used in the
access point mode. If you need to specify other settings, change the
parameters of the DHCP server.
4. After specifying the needed parameters on the Connections Setup /
LAN page, click the APPLY button.
31
To Next Page
Loading...
