24D-Link DCS-850L User Manual
Section 4: Conguration
• Under Lullaby…
Select how long the lullaby will play (in minutes)
when activated
• Under Events…
Change the temperature unit of measure
(Centigrade or Farenheit)
Change the temperature alert range
Tap Check to determine the ambient sound
level. (The level number will change depending
on the noise level in the surrounding area)
Change the Sound Detection level. Set the
Sound Detection Level higher than the Current
Level to receive alerts when noise exceeds the
current level. (A higher detection level means
more noise is required to trigger an event.) You
can put the Detection Level at the lowest setting
to disable sound alerts
Change the Motion Detection sensitivity. You can
also put sensitivity at the lowest setting in order
to disable motion alerts
To Next Page
Loading...
