DCS-935L
4
ENGLISH
MOUNTING THE CAMERA
Please refer to the steps below to assist you with mounting the camera. It is recommended that you
congure the camera before mounting.
mydlink PORTAL
After registering your DCS-935L camera with a mydlink account in the mydlink Lite mobile app, you
will be able to remotely access your camera from the www.mydlink.com website. After signing in to
your mydlink account, you will see a screen similar to the following:
Step 1:
Open Internet Explorer and go to http://www.mydlink.com, then sign into mydlink.
Step 2:
Select your camera from the device list, and your camera’s Live View will appear.
Step 2:
Place the mounting base over the screws that are mounted on the
wall. Make sure to t the screw-heads over the big holes and slide it
downward to lock rmly. Lightly pull the base forward to make sure
that it is locked. Adjust the angle of the camera as desired.
Step 1:
Depending on the material of the wall or ceiling, use proper tools to
drill two holes 25mm deep, 40mm apart with a 6mm drill bit where
you marked. Insert the screws into the holes. If the wall is made out
of concrete, drill the holes rst, then insert the plastic anchors to
support the screws.
1
2
To Next Page
Loading...
Need help?
General
Weight and Dimensions
