2
4
3
5
Rack Installation
The Switch can be mounted in an EIA standard size, 19-inch rack,
which can be placed in a wiring closet with other equipment. To install,
attach the mounting brackets on the switch’s front panel (one on each
side) and secure them with the screws provided.
Attaching the mounting brackets to the Switch
Then, use the screws provided with the equipment rack to mount the
Switch in the rack.
Installing the Switch in an equipment rack
Connecting Network Cable
The Fast Ethernet Switch supports four 10/100Mbps Fast Ethernet ports.
These ports runs both half duplex and full duplex while it’s running in
10Mbps or 100Mbps.
These ports are Auto-MDI type port, these ports can auto transform to
MDI-II or MDI-X type, so you can just make an easy connection that
without worrying if you are using a standard or crossover cable.
Power
To Next Page
Loading...
