Need help?Do you have a question about the D-Link xStack DES-3200-10 and is the answer not in the manual?
General| Number of Ports | 10 |
|---|---|
| Layer | 2 |
| Switching Capacity | 5.6 Gbps |
| Forwarding Rate | 4.17 Mpps |
| MAC Address Table Size | 8K |
| RAM | 32 MB |
| Flash Memory | 8 MB |
| Jumbo Frame Support | Yes |
| VLAN Support | Yes |
| Dimensions | 280 x 180 x 44 mm |
| Weight | 1.5 kg |
| Humidity | 5% to 95% non-condensing |
| Product Type | Managed Switch |
| Ports | 8 x 10/100Base-TX |
| Management | Web-based, SNMP |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -40°C to 70°C |
Steps to access the switch's web interface using a browser and IP address.
Configuration of the switch's IP address, subnet mask, and default gateway.
Configuration of physical port attributes like speed, duplex, and flow control.
Management of user accounts and their privilege levels for switch access.
Configuration of DHCP relay functionality for network address assignment.
Configuration and management of SNMP for network monitoring and device management.
Process for upgrading firmware and managing configuration files via backup/restore.
Configuration to prevent ARP spoofing attacks on the network.
Configuration and management of Virtual Local Area Networks for network segmentation.
Implementation and characteristics of IEEE 802.1Q VLAN tagging for traffic control.
Restricting network access by binding IP addresses to MAC addresses and ports.
Standard for user authentication and network access control using RADIUS.
Authentication and authorization of access based on MAC addresses.
Mitigation of Denial of Service (DoS) attacks to maintain network availability.
Procedures for resetting the switch to factory defaults or rebooting the system.
Process for downloading and updating switch firmware for performance and security.
To Next Page