DES-3000 Series Layer 2 Switch CLI Reference Manual
133
config link_aggregation
group, that is, link aggregation groups may not overlap.
state [enable | disable] Allows the user to enable or disable the specified
link aggregation group.
Restrictions Only Administrator-level users can issue this command. Link aggregation
groups may not overlap and must be contained on a single switch.
Example usage:
To define a load-sharing group of ports, group-id 1,master port 5 of module 1 with group members ports 5-7 plus port 9:
DES-3026:4#config link_aggregation group_id 1
master_port 5 ports 5-7,9
Command: config link_aggregation group_id 1 master_port
5 ports 5-7,9
Success.
DES-3026:4#
NOTE: group_id 3 is designed for the uplink modules only (the last two ports on the
Switch (DES-3010F/FL/G ports 9-10, DES-3018 ports 17-18, DES-3026 ports 25-26) and
can only be configured for them. Any other attempt at configuring group_id 3 with
standard 10/100 Mbps ports will result in a configuration error.
config link_aggregation algorithm
Purpose Used to configure the link aggregation algorithm.
Syntax
config link_aggregation algorithm [mac_source | mac_destination |
mac_source_dest]
Description This command configures to part of the packet examined by the Switch when
selecting the egress port for transmitting load-sharing data. This feature is only
available using the address-based load-sharing algorithm.
Parameters
mac_source Indicates that the Switch should examine the MAC source
address.
mac_destination Indicates that the Switch should examine the MAC destination
address.
mac_source_dest Indicates that the Switch should examine the MAC source
and destination addresses
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure link aggregation algorithm for mac-source-dest:
To Next Page
Loading...
