DES-3000 Series Layer 2 Switch CLI Reference Manual
200
31
ARP COMMANDS
The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command Parameters
show arpentry
{ipif [System] | ipaddress <ipaddr> | static}
config arp_aging time <value 0-65535>
clear arptable
Each command is listed, in detail, in the following sections.
show arpentry
Purpose Used to display the ARP table.
Syntax
show arpentry {ipif [System] | ipaddress <ipaddr> | static}
Description This command is used to display the current contents of the
Switch’s ARP table.
Parameters
ipif [System] The name of the IP interface, the end node or
station for which the ARP table entry was made, or resides on.
<ipaddr> The network address corresponding to the IP interface
name above.
static Displays the static entries to the ARP table.
Restrictions None.
Example usage:
To display the ARP table:
DES-3026:4#show arpentry
Command: show arpentry
ARP Aging Time : 20
Interface IP Address MAC Address Type
--------- ---------- ------------- ----------
System 10.0.0.0 FF-FF-FF-FF-FF-FF Local/Broadcast
System 10.1.1.169 00-50-BA-70-E4-4E Dynamic
System 10.1.1.254 00-01-30-FA-5F-00 Dynamic
System 10.9.68.1 00-A0-C9-A4-22-5B Dynamic
System 10.9.68.4 00-80-C8-2E-C7-45 Dynamic
System 10.10.27.51 00-80-C8-48-DF-AB Dynamic
System 10.11.22.145 00-80-C8-93-05-6B Dynamic
System 10.11.94.10 00-10-83-F9-37-6E Dynamic
System 10.14.82.24 00-50-BA-90-37-10 Dynamic
System 10.15.1.60 00-80-C8-17-42-55 Dynamic
To Next Page
Loading...
