DES-3000 Series Layer 2 Switch CLI Reference Manual
201
System 10.17.42.153 00-80-C8-4D-4E-0A Dynamic
System 10.19.72.100 00-50-BA-38-7D-5E Dynamic
System 10.21.32.203 00-80-C8-40-C1-06 Dynamic
System 10.40.44.60 00-50-BA-6B-2A-1E Dynamic
System 10.42.73.221 00-01-02-03-04-00 Dynamic
System 10.44.67.1 00-50-BA-DA-02-51 Dynamic
System 10.47.65.25 00-50-BA-DA-03-2B Dynamic
System 10.50.8.7 00-E0-18-45-C7-28 Dynamic
System 10.90.90.90 00-01-02-03-04-00 Local
System 10.255.255.255 FF-FF-FF-FF-FF-FF Local/Broadcast
Total Entries = 20
DES-3026:4#
config arp_aging time
Purpose Used to configure the age-out timer for ARP table entries on the Switch.
Syntax
config arp_aging time <value 0-65535>
Description This command sets the maximum amount of time, in minutes, that an
ARP entry can remain in the Switch’s ARP table, without being
accessed, before it is dropped from the table.
Parameters
time <value 0-65535> The ARP age-out time, in minutes. The value
may be set in the range of 0-65535 minutes with a default setting of 20
minutes.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure ARP aging time:
DES-3026:4#config arp_aging time 30
Command: config arp_aging time 30
Success.
DES-3026:4#
clear arptable
Purpose Used to remove all dynamic ARP table entries.
Syntax
clear arptable
Description This command is used to remove dynamic ARP table entries from
the Switch’s ARP table. Static ARP table entries are not affected.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example Usage:
To Next Page
Loading...
