DES-3000 Series Layer 2 Switch CLI Reference Manual
151
config igmp_snooping querier
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure the igmp snooping querier:
DES-3026:4#config igmp_snooping querier vlan_name default
query_interval 125 state enable
Command: config igmp_snooping querier vlan_name default
query_interval 125 state enable
Success.
DES-3026:4#
config router_ports
Purpose Used to configure ports as router ports.
Syntax
config router_ports <vlan_name 32> [add | delete] <portlist>
Description This command allows you to designate a range of ports as being connected
to multicast-enabled routers. This will ensure that all packets with such a
router as its destination will reach the multicast-enabled router regardless
of protocol, etc.
Parameters
<vlan_name 32> The name of the VLAN on which the router port resides.
[add | delete] – Specify whether to add or delete ports defined in the
following parameter <portlist>, to the router port function.
<portlist> Specifies a port or range of ports that will be configured as
router ports.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To set up static router ports:
DES-3026:4#config router_ports default add 1-10
Command: config router_ports default add 1-10
Success.
DES-3026:4#
enable igmp_snooping
Purpose Used to enable IGMP snooping on the Switch.
Syntax
enable igmp_snooping {forward_mcrouter_only}
Description This command allows you to enable IGMP snooping on the Switch. If
forward_mcrouter_only is specified, the Switch will only forward all
multicast traffic to the multicast router, only. Otherwise, the Switch forwards
all multicast traffic to any IP router.
To Next Page
Loading...
