DES-3000 Series Layer 2 Switch CLI Reference Manual
159
Command Parameters
create cpu access_profile profile_id <value 1-3> [ethernet {vlan | source_mac <macmask> |
destination_mac <macmask> | 802.1p | ethernet_type} | ip {vlan |
source_ip_mask <netmask> | destination_ip_mask <netmask> | dscp |
[icmp {type | code} | igmp {type} | tcp {src_port_mask <hex 0x0-0xffff> |
dst_port_mask <hex 0x0-0xffff>} | flag_mask [all | {urg | ack | psh | rst | syn |
fin}]} | udp {src_port_mask <hex 0x0-0xffff> | dst_port_mask <hex 0x0-0xffff>} |
protocol_id_mask {user_mask <hex 0x0-0xffffffff>}]} | packet_content_mask
{offset 0-15 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex
0x0-0xffffffff>| offset 16-31 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-
0xffffffff> <hex 0x0-0xffffffff> | {offset 32-47 <hex 0x0-0xffffffff> <hex 0x0-
0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> | {offset 48-63 <hex 0x0-
0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> | {offset 64-
79 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-
0xffffffff>}]
delete cpu access_profile profile_id <value 1-3>
config cpu access_profile
profile_id <value 1-3> [add access_id <value 1-5> [ethernet {vlan <vlan_name
32> | source_mac <macaddr> | destination_mac <macaddr> | 802.1p <value0-
7> | ethernet_type <hex 0x0-0xffff>} | ip {vlan <vlan_name 32> | source_ip
<ipaddr> | destination_ip <ipaddr> | dscp <value 0-63> | [icmp {type <value 0-
255> code <value 0-255>} | igmp {type <value 0-255>} | tcp {src_port <value 0-
65535> | dst_port <value 0-65535> | {urg | ack | psh | rst | syn | fin}]} | udp
{src_port <value 0-65535> | dst_port <value 0-65535>} | protocol_id <value 0 -
255> {user_define <hex 0x0-0xffffffff>}]} | packet_content {offset_0-15 <hex
0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff>|
offset_16-31 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex
0x0-0xffffffff> | offset_32-47 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-
0xffffffff> <hex 0x0-0xffffffff> | offset_48-63 <hex 0x0-0xffffffff> <hex 0x0-
0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> | offset_64-79 <hex 0x0-
0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff>}] port
[<portlist> | all] [permit | deny] | delete access_id <value 1-5>]
enable cpu_interface_filtering
disable cpu_interface_filtering
show cpu_access_profile profile_id <value 1-3>
Each command is listed, in detail, in the following sections.
To Next Page