DES-3000 Series Layer 2 Switch CLI Reference Manual
174
Example usage:
To display the 802.1x authentication states (stacking disabled) for Port-based 802.1x:
DES-3026:4#show 802.1x auth_state ports 1-5
Command: show 802.1x auth_state ports 1-5
Port Auth PAE State Backend State Port Status
------ -------------- ------------- ------------
1 ForceAuth Success Authorized
2 ForceAuth Success Authorized
3 ForceAuth Success Authorized
4 ForceAuth Success Authorized
5 ForceAuth Success Authorized
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
Example usage:
To display the 802.1x authentication states (stacking disabled) for MAC-based 802.1x:
DES-3026:4#show 802.1x auth_state
Command: show 802.1x auth_state
Port number : 1
Index MAC Address Auth PAE State Backend State Port Status
------ ------------ --------------- ------------- -----------
1 00-08-02-4E-DA-FA Authenticated Idle Authorized
2
3
4
5
6
7
8
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
show 802.1x auth_configuration
Purpose Used to display the current configuration of the 802.1x server on the Switch.
Syntax
show
802.1x auth_configuration {ports <portlist>}
Description The show 802.1x command is used to display the current configuration of the
802.1x Port-based Network Access Control server application on the Switch.
The following details what is displayed:
802.1x Enabled/Disabled Shows the current status of 802.1x functions on
the Switch.
Authentication Protocol: Radius_Eap Shows the authentication protocol suite
in use between the Switch and a RADIUS server.
Port number Shows the physical port number on the Switch.
Capability: Authenticator/None Shows the capability of 802.1x functions on
the port number displayed above. There are four 802.1x capabilities that can
be set on the Switch: Authenticator, Supplicant, Authenticator and Supplicant,
and None.
Port Status: Authorized/Unauthorized Shows the result of the authentication
To Next Page
Loading...
