DES-3000 Series Layer 2 Switch CLI Reference Manual
14
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
show switch
Purpose Used to display information about the Switch.
Syntax
show switch
Description This command displays information about the Switch.
Parameters None.
Restrictions None.
Example usage:
To display the Switch information:
DES-3026:4#show switch
Command: show switch
Device Type : DES-3026 Fast Ethernet Switch
Module 1 Type : None
Module 2 Type : None
MAC Address : 00-1C-F0-11-69-59
IP Address : 10.73.21.26 (Manual)
VLAN Name : default
Subnet Mask : 255.0.0.0
Default Gateway : 0.0.0.0
Boot PROM Version : Build 1.01.009
Firmware Version : Build 4.20.B27
Hardware Version : A3
System Name :
System Location :
System Contact :
Spanning Tree : Disabled
LoopBack Detection : Disabled
IGMP Snooping : Disabled
VLAN trunk : Disabled
802.1X : Disabled
TELNET : Enabled(TCP 23)
WEB : Enabled(TCP 80)
RMON : Disabled
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
show config
Purpose Used to display a list of configuration commands entered into the
Switch.
To Next Page
Loading...
