DES-3000 Series Layer 2 Switch CLI Reference Manual
190
To configure the configurations for a previously created 802.1x Guest VLAN.
DES-3026:4#show 802.1x guest_vlan
Command: show 802.1x guest_vlan
Guest VLAN Setting
-------------------------------------------------------
Guest VLAN : Trinity
Enable Guest VLAN ports: 5-8
DES-3026:4#
delete 802.1x guest_vlan
Purpose Used to delete a 802.1x Guest VLAN.
Syntax
delete 802.1x guest_vlan <vlan_name 32>
Description
The delete 802.1x guest_vlan command is used to delete an
802.1x Guest VLAN. Guest 802.1X VLAN clients are those who
have not been authorized for 802.1x or they haven’t yet installed the
necessary 802.1x software, yet would still like limited access rights
on the Switch.
Parameters <vlan_name 32> – Enter the VLAN name of the Guest 802.1x VLAN
to be deleted.
Restrictions Only Administrator-level users can issue this command.
Users must have already previously created a VLAN using the
create vlan command. Only one VLAN can be set as the 802.1x
Guest VLAN.
Example usage:
To delete a previously created 802.1x Guest VLAN.
DES-3026:4#delete 802.1x guest_vlan Trinity
Command: delete 802.1x guest_vlan Trinity
Success.
DES-3026:4#
config 802.1x fws_pdu system
Purpose Used to configure forwarding of EAPOL PDU when 802.1x is
disabled.
Syntax
config 802.1x fwd_pdu system [enable | disable]
Description This is a global setting to control the forwarding of EAPOL PDU.
When 802.1x functionality is disabled globally or disabled for a single
port, and 802.1x fwd_pdu is enabled both globally and for a single
port, a received EAPOL packet on the port will be flooded to the
same VLAN as those ports which 802.1x fp fwd_pdu du is enabled
and 802.1x is disabled (globally or just for a single port). The default
state is disabled.
To Next Page