DES-3000 Series Layer 2 Switch CLI Reference Manual
208
To view SIM neighbors:
DES-3026:4#show sim neighbor
Command: show sim neighbor
Neighbor Info Table
Port MAC Address Role
------ ------------------ ---------
23 00-35-26-00-11-99 Commander
23 00-35-26-00-11-91 Member
24 00-35-26-00-11-90 Candidate
Total Entries: 3
DES-3026:4#
reconfig
Purpose Used to connect to a member switch, through the commander switch
using Telnet.
Syntax
reconfig [member_id <value 1-32> | exit]
Description This command is used to reconnect to a member switch using telnet.
Parameters member_id <value 1-32> – Select the ID number of the member
switch to configure.
exit – This command is used to exit from managing the member
switch and will return to managing the commander switch.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To connect to the MS, with member ID 2, through the CS, using the command line interface:
DES-3026:4#reconfig member_id 2
Command: reconfig member_id 2
DES-3026:4#
config sim_group
Purpose Used to add members and delete members from the SIM group.
Syntax
config sim_group [add <candidate_id 1-100> {<password>} |
delete <member_id 1-32>]
Description This command is used to add candidates and delete members from
the SIM group by ID number.
Parameters add <candidate_id 1-100> <password> – Use this parameter to
change a candidate switch (CaS) to a member switch (MS) of a SIM
group. The CaS may be defined by its ID number and a password (if
necessary).
To Next Page