DES-3000 Series Layer 2 Switch CLI Reference Manual
25
config ports
mdix – MDIX mode can be specified as auto, normal, and cross
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure the speed of ports 1-3 to be 10 Mbps, full duplex and state enabled:
DES-3026:4#config ports 1-3 speed 10_full state enable
Command: config ports 1-3 speed 10_full state enable
Success.
DES-3026:4#
show ports
Purpose Used to display the current configuration of a range of ports.
Syntax
show
ports {<portlist>} {description | err_disabled}
Description This command is used to display the current configuration of a range
of ports.
Parameters <portlist> – Specifies a port or range of ports to be displayed.
description – Adding this parameter to the command will allow the
user to view previously configured descriptions set on various ports
on the Switch.
err_disabled – Used to view information about ports that have had
their connection status disabled, for reasons such as link down
status.
Restrictions None.
Example usage:
To display the configuration of ports 1-5 on the Switch:
DES-3026:4#show ports 1-5
Command: show ports 1-5
Port State/ Settings Connection Address
Mdix Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
--- -------- --------------------- --------------------- --------
1 Enabled Auto/Enabled 100/Full/none Enabled
Normal
2 Enabled Auto/Enabled Link Down Enabled
Normal
3 Enabled Auto/Enabled Link Down Enabled
Normal
4 Enabled Auto/Enabled Link Down Enabled
Normal
5 Enabled Auto/Enabled Link Down Enabled
Normal
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
Example usage:
To display port descriptions:
To Next Page
Loading...
