DES-3000 Series Layer 2 Switch CLI Reference Manual
43
create trusted_host
Parameters
<ipaddr> The IP address of the trusted host to be created.
network <network_address> – Users may enter this parameter to
configure a trusted network for the device, using an IP address with
the appropriate subnet mask.. (ex. If an IP address of 10. 53.13.1/8
was added here, it would constitute all address from 10.0.0.0 –
10.255.255.255 as trusted IP addresses, or in essence the whole 10
dot network.)
Restrictions Only Administrator-level users can issue this command.
Example usage:
To create the trusted host:
DES-3026:4#create trusted_host 10.48.74.121
Command: create trusted_host 10.48.74.121
Success.
DES-3026:4#
Example usage:
To create the trusted network:
DES-3026:4#create trusted_host network 11.0.0.0/8
Command: create trusted_host network 11.0.0.0/8
Success.
DES-3026:4#
show trusted_host
Purpose Used to display a list of trusted hosts entered on the Switch using
the create trusted_host command above.
Syntax
show trusted_host
Description This command is used to display a list of trusted hosts entered on
the Switch using the create trusted_host command above.
Parameters None.
Restrictions None.
Example usage:
To display the list of trust hosts:
DES-3026:4#show trusted_host
Command: show trusted_host
Management Stations
IP Address
-----------------------
10.0.0.0/8
11.1.2.3
Total Entries: 1
To Next Page
Loading...
