DES-3000 Series Layer 2 Switch CLI Reference Manual
81
DES-3026:4#config syslog host all severity all
facility local0
Command: config syslog host all severity all
facility local0
Success.
DES-3026:4#
delete syslog host
Purpose Used to remove a syslog host that has been previously configured,
from the Switch.
Syntax
delete syslog host [<index 1-4> | all]
Description
The delete syslog host command is used to remove a syslog host
that has been previously configured from the Switch.
Parameters
<index 1-4> Specifies that the command will be applied to an index
of hosts. There are four available indexes, numbered 1 through 4.
all Specifies that the command will be applied to all hosts.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To delete a previously configured syslog host:
DES-3026:4#delete syslog host 4
Command: delete syslog host 4
Success.
DES-3026:4#
show syslog host
Purpose Used to display the syslog hosts currently configured on the Switch.
Syntax
show syslog host {<index 1-4>}
Description
The show syslog host command is used to display the syslog
hosts that are currently configured on the Switch.
Parameters
<index 1-4> Specifies that the command will be applied to an index
of hosts. There are four available indexes, numbered 1 through 4.
Restrictions None.
Example usage:
To show Syslog host information:
To Next Page
Loading...
