DES-3000 Series Layer 2 Switch CLI Reference Manual
93
DES-3026:4#config loopdetect ports 1-10
state enable
Command: config loopdetect ports 1-10
state enable
Success.
DES-3026:4#
show loopdetect ports
Purpose Used to display the Loopback Detection port settings on the switch.
Syntax
show
loopdetect ports {<portlist>}
Description This command will display the loopdetect port settings currently set
on the switch.
Parameters <portlist> – Enter a port or range of ports to be displayed. Not
entering this parameter will display all ports on the switch.
Restrictions None.
Example usage:
To display the loopback detection parameters:
DES-3026:4#show loopdetect ports 1-5
Command: show loopdetect ports 1-5
Port Loopdetect State Loop status
-------- ------------------------- -------------------
1 Enabled Normal
2 Enabled Normal
3 Enabled Normal
4 Enabled Normal
5 Disabled Normal
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r
Refresh
To Next Page
Loading...
