DES-3000 Series Layer 2 Switch CLI Reference Manual
128
19
VLAN TRUNK COMMANDS
The VLAN Trunk commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
enable vlan_trunk
disable vlan_trunk
config vlan_trunk ports
[<portlis
t>|all] state [enable|disable] show vlan_trunk
Each command is listed, in detail, in the following sections.
enable vlan_trunk
Purpose Used to enable VLAN trunking on the switch.
Syntax
enable vlan_trunk
Description When the VLAN trunk function is enabled, the VLAN trunk ports shall be
able to forward all tagged frames with any VID.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To enable VLAN trunk:
DES-3026:4# enable vlan_trunk
Command: enable vlan_trunk
Success
DES-3026:4#
To Next Page
Loading...
