DES-3000 Series Layer 2 Switch CLI Reference Manual
10
4
BASIC SWITCH COMMANDS
The basic switch commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
enable password
encryption
disable password
encryption
config account <username> {encrypt [plain_text | sha_1] <password>}
delete account <username> {force_agree}
show account
show session
show switch
show config [current_config | config_in_nvram]
show serial_port
config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] |auto_logout [never |
2_minutes | 5_minutes| 10_minutes | 15_minutes]}
enable clipaging
disable clipaging
enable telnet {<tcp_port_number 1-65535>}
disable telnet
enable web {<tcp_port_number 1-65535>}
disable web
save {[config | log | all]}
reboot {force_agree}
reset {[config | system]} {force_agree}
login
logout
ping <ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
config terminal_line [default | <value 20-80>]
show terminal_line
Each command is listed, in detail, in the following sections.
To Next Page
Loading...
