DES-3000 Series Layer 2 Switch CLI Reference Manual
11
enable/disable password encryption
Purpose Used to create user accounts.
Syntax
enable password encryption
disable password encryption
Description
The user account configuration information will be stored in the
configuration file, and can be applied to the system later.
If the password encryption is enabled, the password will be in
encrypted form.
When password encryption is disabled, if the user specifies the
password in plain text form, the password will be in plain text form.
However, if the user specifies the password in encrypted form, or if
the password has been converted to encrypted form by the last
enable password encryption command, the password will still be in
the encrypted form. It can not be reverted to the plain text form.
Parameters None
Restrictions Only Administrator-level users can issue this command.
Example usage:
To enable password encryption.
DES-3026:4# enable password encryption
Command: enable password encryption
Success.
DES-3026:4#
create account
Purpose Used to create user accounts.
Syntax
create [admin | user] <username 15>
Description The create account command is used to create user accounts that
consists of a username of 1 to 15 characters and a password of 0
to 15 characters. Up to 8 user accounts can be created.
Parameters admin <username>
user <username>
Restrictions Only Administrator-level users can issue this command.
Usernames can be between 1 and 15 characters.
Passwords can be between 0 and 15 characters.
Example usage:
To create an administrator-level user account with the username “dlink”.
DES-3026:4#create account admin dlink
Command: create account admin dlink
Enter a case-sensitive new password:****
Enter the new password again for confirmation:****
Success.
To Next Page
Loading...
