DES-3000 Series Layer 2 Switch CLI Reference Manual
132
DES-3026:4#create link_aggregation
group_id 1
Command: create link_aggregation
group_id 1
Success.
DES-3026:4#
delete link_aggregation group_id
Purpose Used to delete a previously configured link aggregation group.
Syntax
delete link_aggregation group_id <value 1-3>
Description This command is used to delete a previously configured link aggregation
group.
Parameters
<value 1-3> Specifies the group ID. The Switch allows up to 3 link
aggregation groups to be configured. The group number identifies each of
the groups. group_id 3 is designed for the uplink modules only (the last two
ports on the Switch (9-10, 17-18, 25-26) and can only be configured for
them.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To delete link aggregation group:
DES-3026:4#delete link_aggregation group_id 1
Command: delete link_aggregation group_id 1
Success.
DES-3026:4#
config link_aggregation
Purpose Used to configure a previously created link aggregation group.
Syntax
config link_aggregation group_id <value 1-3> {master_port <port> |
ports <portlist> | state [enable | disable]}
Description This command allows configuration of a link aggregation group that was
created with the create link_aggregation command above.
Parameters
<value 1-3> Specifies the group ID. The Switch allows up to 3 link
aggregation groups to be configured. The group number identifies each of
the groups. group_id 3 is designed for the uplink modules only (the last two
ports on the Switch (9-10, 17-18, 25-26) and can only be configured for
them.
master port <port> Master port ID. Specifies which port (by port number)
of the link aggregation group will be the master port. All of the ports in a link
aggregation group will share the port configuration with the master port.
ports <portlist> Specifies a port or range of ports that will belong to the
link aggregation group. Ports may be listed in only one port aggregation
To Next Page
Loading...
