D-Link DES-3010G - Page 199

DES-3000 Series Layer 2 Switch CLI Reference Manual
195
DES-3026:4#config time 30062003 16:30:30
Command: config time 30062003 16:30:30
Success.
DES-3026:4#
config time_zone
Purpose Used to determine the time zone used in order to adjust the system clock.
Syntax
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min
<minute 0-59>}
Description This will adjust system clock settings according to the time zone. Time zone
settings will adjust SNTP information accordingly.
Parameters operator – Choose to add (+) or subtract (-) time to adjust for time zone
relative to GMT.
hour – Select the number hours offset from GMT (Greenwich Mean Time).
min – Select the number of minutes difference added or subtracted to
adjust the time zone.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To configure time zone settings:
DES-3026:4#config time_zone operator + hour 2 min
30
Command: config time_zone operator + hour 2 min 30
Success.
DES-3026:4#
config dst
Purpose Used to enable and configure time adjustments to allow for the use of Daylight
Savings Time (DST).
Syntax
config dst [disable | repeating {s_week <start_week 1-4,last> | s_wday
<start_weekday sun-sat>| s_mth <start_mth 1-12> | s_time <start_time
hh:mm> | e_week <end_week 1-4,last> | e-wday <end_weekday sun-sat> |
e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 |
120]} | annual {s_date <start_date 1-31> | s_mth <start_mth 1-12> | s_time
<start_time hh:mm> | e_date <end_date 1-31> | e_mth <end_mth 1-12> |
e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]}]
Description DST can be enabled and configured using this command. When enabled this will
adjust the system clock to comply with any DST requirement. DST adjustment
effects system time for both manually configured time and time set using SNTP
service.
Parameters disable – Disable the DST seasonal time adjustment for the Switch.
repeating – Using repeating mode will enable DST seasonal time adjustment.
Repeating mode requires that the DST beginning and ending date be specified