DES-3000 Series Layer 2 Switch CLI Reference Manual
209
config sim_group
delete <member_id 1-32> – Use this parameter to delete a member
switch of a SIM group. The member switch should be defined by it ID
number.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To add a member:
DES-3026:4#config sim_group add 2
Command: config sim_group add 2
Please wait for ACK...
SIM Config Success !!!
Success.
DES-3026:4#
To delete a member:
DES-3026:4#config sim_group delete 1
Command: config sim_group delete 1
Please wait for ACK...
Success.
DES-3026:4#
config sim
Purpose Used to configure role parameters for the SIM protocol on the Switch.
Syntax
config sim [[commander {group_name <groupname 64>} | candidate] |
dp_interval <30-90> | hold_time <sec 100-255>]]
Description This command is used to configure parameters of switches of the SIM.
Parameters commander – Use this parameter to configure the commander switch for the
following parameters:
group_name <groupname 64> – Used to update the name of the group. Enter an
alphanumeric string of up to 64 characters to rename the SIM group.
dp_interval <30-90> – The user may set the discovery protocol interval, in
seconds that the Switch will send out discovery packets. Returning information to
the commander switch will include information about other switches connected to
it. (Ex. MS, CaS). The user may set the discovery protocol interval from 30 to 90
seconds.
hold time <sec 100-255> – Using this parameter, the user may set the time, in
seconds, the Switch will hold information sent to it from other switches, utilizing
the discovery interval protocol. The user may set the hold time from 100 to 255
seconds.
To Next Page
Loading...
