DES-3000 Series Layer 2 Switch CLI Reference Manual
221
34
COMMAND HISTORY LIST
The command history list commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
? {<command>}
show command_history
dir
config command_history <value 1-40>
Each command is listed, in detail, in the following sections.
?
Purpose Used to display all commands in the Command Line Interface (CLI).
Syntax
? {<command>}
Description This command will display all of the commands available through the
Command Line Interface (CLI).
Parameters
<command> Entering the question mark with an appropriate command
will list all the corresponding parameters for the specified command, along
with a brief description of the commands function and similar commands
having the same words in the command.
Restrictions None.
Example usage
To display all of the commands in the CLI:
DES-3026:4#?
Command: ?
..
?
cable_diag ports
clear
clear arptable
clear counters
clear fdb
clear log
clear port_security_entry port
config 802.1p default_priority
config 802.1p user_priority
config 802.1x auth_mode
config 802.1x auth_parameter ports
config 802.1x auth_protocol
config 802.1x capability ports
config 802.1x fwd_pdu ports
To Next Page
Loading...
