DES-3000 Series Layer 2 Switch CLI Reference Manual
19
enable web
Purpose Used to enable the HTTP-based management software on the
Switch.
Syntax
enable web {<tcp_port_number 1-65535>}
Description This command is used to enable the Web-based management
software on the Switch.
Parameters
<tcp_port_number 1-65535> The TCP port number. TCP ports
are numbered between 1 and 65535. The “well-known” port for the
Web-based management software is 80.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To enable HTTP and configure port number:
DES-3026:4#enable web 80
Command: enable web 80
Success.
DES-3026:4#
disable web
Purpose Used to disable the HTTP-based management software on the
Switch.
Syntax
disable web
Description This command disables the Web-based management software on
the Switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To disable HTTP:
DES-3026:4#disable web
Command: disable web
Success.
DES-3026:4#
To Next Page
Loading...
