DES-3000 Series Layer 2 Switch CLI Reference Manual
42
enable rmon
Purpose Used to enable RMON on the Switch.
Syntax
enable rmon
Description
This command is used, in conjunction with the disable rmon
command below, to enable and disable remote monitoring (RMON)
on the Switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To enable RMON:
DES-3026:4#enable rmon
Command: enable rmon
Success.
DES-3026:4#
disable rmon
Purpose Used to disable RMON on the Switch.
Syntax
disable rmon
Description
This command is used, in conjunction with the enable rmon
command above, to enable and disable remote monitoring (RMON)
on the Switch.
Parameters None.
Restrictions Only Administrator-level users can issue this command.
Example usage:
To disable RMON:
DES-3026:4#disable rmon
Command: disable rmon
Success.
DES-3026:4#
create trusted_host
Purpose Used to create the trusted host.
Syntax
create trusted_host [<ipaddr> | network <network_address>]
Description
The create trusted_host command creates the trusted host. The
Switch specification of up to ten IP addresses that are allowed to
manage the Switch via in-band SNMP or TELNET based
management software. These IP addresses must be members of the
Management VLAN. If no IP addresses are specified, then there is
nothing to prevent any IP address from accessing the Switch,
provided the user knows the Username and Password.
To Next Page
Loading...
