xStack DES-3526 / DES-3526DC Layer 2 Stackable Fast Ethernet Managed Switch User Manual
98
Initializing Ports for MAC Based 802.1x
To initialize ports for the MAC side of 802.1x, the user must first enable 802.1x by MAC address in the Advanced Settings
window. Click Configuration > Port Access Entity > PAE System Control > Initialize Port(s) to open the following window:
Figure 6- 80. Initialize Port(s) window (MAC based 802.1x)
To initialize ports, first choose the switch in the switch stack by using the Unit pull-down menu, then the range of ports in the
From and To field. Then the user must specify the MAC address to be initialized by entering it into the MAC Address field and
checking the corresponding check box. To begin the initialization, click Apply.
NOTE: The user must first globally enable 802.1X in the Switch Information
(Advanced Settings) window in the Configuration folder before initializing ports.
Information in the Initialize Ports Table cannot be viewed before enabling 802.1X.
Reauthenticate Port(s) for Port Based 802.1x
This window allows you to reauthenticate a port or group of ports by choosing a port or group of ports by using the pull down
menus From and To and clicking Apply. The Reauthenticate Port Table displays the current status of the reauthenticated port(s)
once you have clicked Apply.
Click Configuration > Port Access Entity > PAE System Control > Reauthenticate Port(s) to open the Reauthenticate
Port(s) window:
Figure 6- 81. Reauthenticate Port window
This window displays the following information:
To Next Page
Loading...
