xStack DES-3526 / DES-3526DC Layer 2 Stackable Fast Ethernet Managed Switch User Manual
84
Figure 6- 63. Access Rule Table window (Ethernet)
The user may search for the settings of a particular Access ID by entering that ID into the Access ID field above and clicking
Find. The user may display all Access ID entries by clicking the View All Entry button.
To remove a previously created rule, select it and click the
button. To add a new Access Rule, click the Add button:
Figure 6- 64. Access Rule Configuration window (Ethernet)
To set the Access Rule for Ethernet, adjust the following parameters and click Apply.
Parameters Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the Switch, according to any additional rule, forwards the
packets that match the access profile added (see below).
Select Deny to specify that packets that do not match the access profile are not forwarded by
the Switch and will be filtered.
Access ID (1-65535)
Type in a unique identifier number for this access or use Auto Assign.
Type
Selected profile based on Ethernet (MAC Address), IP address or Packet Content Mask.
• Ethernet instructs the Switch to examine the layer 2 part of each packet header.
• IP instructs the Switch to examine the IP address in each frame's header.
• Packet Content Mask instructs the Switch to examine the packet header
To Next Page
Loading...
