xStack DES-3526 / DES-3526DC Layer 2 Stackable Fast Ethernet Managed Switch User Manual
81
Figure 6- 59. Access Profile Configuration window (Packet Content Mask)
This screen will aid the user in Switch to mask packet headers beginning with the offset value specified. The following fields are
used to configure the Packet Content Mask:
Parameter Description
Profile ID (1-255)
Type in a unique identifier number for this profile set. This value can be set from 1 to 255.
Type
Select profile based on Ethernet (MAC Address), IP address or Packet Content Mask. This will
change the menu according to the requirements for the type of profile.
• Select Ethernet to instruct the Switch to examine the layer 2 part of each packet
header.
• Select IP to instruct the Switch to examine the IP address in each frame's header.
• Select Packet Content Mask to specify a mask to hide the content of the packet
header.
Offset
This field will instruct the Switch to mask the packet header beginning with the offset value
specified:
• value (0-15) - Enter a value in hex form to mask the packet from the beginning of the
packet to the 16th byte.
• value (16-31) – Enter a value in hex form to mask the packet from byte 16 to byte 31.
• value (32-47) – Enter a value in hex form to mask the packet from byte 32 to byte 47.
• value (48-63) – Enter a value in hex form to mask the packet from byte 48 to byte 63.
• value (64-79) – Enter a value in hex form to mask the packet from byte 64 to byte 79.
Click Apply to implement changes made.
To establish the rule for a previously created Access Profile:
To Next Page
Loading...
