4 Configuration D-Link Smart Managed Switch User Manual
26
The fields that can be configured for 802.1Q VLAN are described below:
Item Description
VID Enter the VID to be created.
VLAN Name Enter the VLAN name for the VID to be created.
Port
Assign ports as Untag, Tag or Not Member. Click All to select all
ports.
Table 4.16
Click Apply to create a new VID group.
To configure the PVID settings, click PVID Settings and the following will be displayed:
Figure 4.31 – L2 Features > VLAN > 802.1Q VLAN – PVID Settings
Click Apply to make the configurations take effect.
Click Cancel to discard any changed made and return to the previous page.
L2 Features > VLAN > Port-Based VLAN
Port-Based VLANs are the simplest and most common form of VLAN. It assigns physical LAN ports to
VLANs, effectively broadening their application. You can assign multiple ports to the same VLAN, or each
port to a separate VLAN. The default is disabled.
Figure 4.31 – L2 Features > VLAN > Port-Based VLAN
Select Enabled and click Apply to enable the Port-Based VLAN function and the following will be displayed:
Figure 4.32 – L2 Features > VLAN > Port-Based VLAN - Enabled
Click Rename to rename the VLAN group.
Click Delete to remove the VLAN group.
NOTE: When Port-Based VLAN is enabled, the
802.1Q VLAN settings and 802.1Q management
VLAN settings would be
automatically.
To create a new Port-Based VLAN group, click Add VLAN and the following will be displayed:
To Next Page
Loading...
