D-Link DGS-1100 MP/MPP Series Switch User Manual
19
Click the Exit button to discard the changes made, exit the Smart Wizard, and continue to the
Standard Mode Web UI.
Click the Next button to accept the changes made and continue to the next step.
Step 2 – System IP Information
In this window, the user can configure the IP address assignment method, the static IP address,
netmask and gateway address.
NOTE: The switch will probe IP-Cameras every 30 seconds. If an IP-Camera is
not in the same subnet as the switch, the IP-Camera will not be automatically
discovered. Place the switch management IP in the same subnet as the IP-
Cameras for the cameras to be automatically added to the Surveillance Mode
Web UI.
Figure 4-3 System IP Information window
To Next Page
Loading...
