DGS-3100 Series Gigabit Stackable Managed Switch Hardware Installation Guide
39
Restore Default Button
Reboot Device
This section contains instructions for rebooting device. A Restore Default Button that is used to reboot device after press the
button.
DGS3100#
To perform reset to factory defaults please do not release the button during 5
seconds
**************************************************
***************** SYSTEM RESET *****************
**************************************************
Restore Default Settings
This section contains instructions for restoring default settings. A Restore Default Button that is used to restore default
settings. To restore defaults settings the button must be held down for five seconds. It will delete startup configuration
automatically.
DGS3100#
To perform reset to factory defaults please do not release the button during 5
seconds
Deleting auto update backup file...OK
Deleting auto update instruction file...OK
Deleting startup configuration file... Done.
Please make sure that your terminal is set to the default baud rate - 9600 bps.
**************************************************
***************** SYSTEM RESET *****************
**************************************************
To Next Page
Loading...
