Need help?Do you have a question about the D-Link DGS-3130-54TS and is the answer not in the manual?
General| Power over Ethernet (PoE) | No |
|---|---|
| Switching Capacity | 176 Gbps |
| MAC Address Table Size | 32K |
| RAM | 512 MB |
| Flash Memory | 32 MB |
| Power Supply | Internal |
| Rack Mountable | Yes |
| Device Type | Managed |
| Primary Type | Layer 3 |
| Port Type | 10/100/1000 Mbps |
| Jumbo Frame | 9KB |
| Operating Temperature | 0 to 50 °C |
| Storage Temperature | -40°C to 70°C |
| Humidity | 5% to 95% (non-condensing) |
Details the D-Link DGS-3130 Series as a high performance Layer 3 switch.
Describes front, rear, and side panel components for the DGS-3130-30TS model.
Details the ports and LED indicators found on the front panel of the switch.
Identifies the security lock, GND, AC power connector, and RPS port on the rear panel.
Provides essential hardware installation guidelines for safe and proper switch setup.
Guide to mounting the switch securely into a standard 19-inch rack.
Information on connecting an optional Redundant Power Supply for reliability.
Details on how to stack multiple switches for unified management and scalability.
Procedure for establishing a console connection for switch configuration.
Steps to assign an IP address for network management of the switch.
How to use the dedicated MGMT port for out-of-band network management.
Step-by-step guide to access the switch's web management interface.
Comprehensive explanation of all switch LEDs, their colors, and statuses.
Defines the terms, conditions, and duration of the hardware and software warranty.
To Next Page
