Need help?Do you have a question about the D-Link DGS-3100 and is the answer not in the manual?
General| Flash Memory | 16 MB |
|---|---|
| Jumbo Frame Support | Yes |
| VLAN Support | Yes |
| Uplink Ports | 4 SFP ports (combo with 10/100/1000BASE-T ports on 24-port model) |
| Number of VLANs | 4K |
| Layer | Layer 2 |
| Management | Web-based, SNMP, CLI |
| Dimensions | 440 x 260 x 44 mm (24-port model), 440 x 260 x 44 mm (48-port model) |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -40°C to 70°C |
| Humidity | 10% to 90% non-condensing |
Procedures for saving and retrieving device configurations using HTTP or TFTP.
Steps to update the switch's firmware using an HTTP or TFTP server.
Assigning static or dynamic IP addresses, subnet masks, and gateways to the switch.
Configuring virtual switch configurations by grouping multiple units for enhanced flexibility.
Configuring port properties such as speed, duplex mode, and flow control.
Segmenting the network into logical broadcast domains using IEEE 802.1Q VLANs.
Preventing Layer 2 loops by configuring Spanning Tree Protocol (STP) on the network.
Limiting access on specific ports to authorized MAC addresses for enhanced network security.
Authenticating users on a per-port basis using an external RADIUS server via 802.1X.
Configuring Power over Ethernet (PoE) settings, including port enable and power limits.
Intuitively configuring Access Control Lists (ACLs) by creating profiles and rules.
To Next Page