DGS-3100 Series Gigabit Stackable Managed Switch User Manual
Defining Trunking
The Trunking Configuration Page contains information for assigning ports to LAGs and defining LAG parameters. To
assign ports to LAGs:
1. Click L2 Features > Trunking. The
Trunking Configuration Page opens:
Figure 3–8. Trunking Configuration Page
The
Trunking Configuration Page contains the following fields:
Field Description
Unit
Defines the stacking member’s Unit ID for which LAG parameters are displayed.
Group ID
Displays the LAG number.
Type
Defines the LAG type. The possible field values are:
Static — The LAG is static; LACP is disabled on the LAG. (This is the default value).
LACP — LACP is enabled on the device..
Ports
Displays the ports which are included in the LAG.
2. Select a stacking unit in the Unit field.
3. Define the Group ID and Type fields.
4. Check the ports to be added to the LAG. The port numbers are displayed in the Ports field.
5. Click
. The LAG settings are saved, and the device is updated.
65
To Next Page
Loading...
