Information in this document is subject to change without notice.
© 2021 D-Link Corporation. All rights reserved.
Package Contents
Open the shipping carton of the Switch and carefully unpack its contents. The carton
should contain the following items:
One DGS-3130-54TS switch
One AC power cord
One console cable (RJ-45 to RS-232)
One rack mounting kit (two brackets and screws)
Four rubber feet with adhesive backing
One power cord retainer set
One Quick Installation Guide
LEDs
LED Status Description
Power Solid green Device power on.
Light off Device power off.
Console Solid green Console on.
Light off Console off.
MGMT Solid green Link presents but not sending or receiving data.
Blinking Port is sending or receiving data.
Light off No link or port was administratively shutdown.
USB Solid green USB disk is connected.
Blinking Data is transmitting.
Light off No device is connected.
RPS Solid green RPS in using.
Light off RPS off.
Fan Error Solid yellow The fan has run time failure and is brought offline.
Light off All fans work normally.
Stack ID Capable 1-8 The Box ID is assigned in the stack.
When the box becomes stacking master, the box ID and «H»
will be shown by turn. That is boxID -> H -> boxID -> H … off.
Link/Activity/Speed
(per 10/100/1000Base-T
port)
Solid green When there is a secure 1000 Mbps connection at the port.
Blinking green When there is reception or transmission occuring at the port.
Solid amber When there is a secure 10/100 Mbps connection at the port.
Blinking amber When there is reception or transmission occuring at the port.
Light off No link.
Link/Activity/Speed
(per 10GBase-T port)
Solid green When there is a secure 10 Gbps connection at the port.
Blinking green When there is reception or transmission occuring at the port.
To Next Page
Loading...
