D-Link DGS-3630 SERIES How To Set Up

- 1 -
How to set up the Stack on DGS-3x20 Switch Series
Physical stacking is only supported and working within the same Switch family (f.e. DGS-3420-Series, DGS-
3620-Series, DGS-3120-Series, DGS-1510-Series,..).
Stacking also ONLY works when using 10GBit/s (or in some cases 120GBit/s) connections.
For the DGS-3120-Series the Stacking Ports are located on the BACK of the switch and have an Infiniband
connector.
For all other Stackable Series like DGS-1510, DGS-3420, DGS-3620, DGS-3630, DXS-3400 the Stacking ports
are always the last 2 10GBit Ports.
For the DXS-3600 Series you need a dedicated 120GBit XFP Stacking module and commands. Please refer to
the dedicated manual and datasheet.
We recommend the build of a “RING” stack for stability purposes when using 3 or more devices in a stack.
Alternatively you also can set up a “DUPLEX CHAIN” stack with the lack of redundancies.

D-Link DGS-3630 SERIES Specifications

General

Layer	Layer 3
MAC Address Table Size	32K
Power Supply	100-240V AC, 50/60Hz
Management	CLI, SNMP
Standards Compliance	IEEE 802.1D, IEEE 802.1Q, IEEE 802.1w, IEEE 802.1s, IEEE 802.3ad, IEEE 802.3x
Dimensions	440 x 250 x 44 mm (17.3 x 9.8 x 1.7 inches)
Power over Ethernet (PoE)	Available on some models (DGS-3630-28PC, DGS-3630-52PC)