D-Link DI-804HV - Reset to Factory Defaults

94
After you have tried other methods for troubleshooting your network, you
may choose to Reset the DI-804HV to the factory default settings.
To hard-reset the D-Link DI-804HV to the Factory Default Settings, please do
the following:
Resetting the DI-804HV to the
Factory Default Settings
n
n Use a paper clip to press the Reset button and
power on.
Locate the Reset button on the back of the DI-804HV
n
After you have completed the above steps, the DI-804HV
will be reset to the factory default settings
n
Hold for about 5 seconds (don’t hold too long) and
then release. (Or, release when M1 and M2 flash
at the same time.)